Using Cruncher from a command line

Exchanges about Polygon Cruncher
Post Reply
Kier
Posts: 1
Joined: Wed Jan 30, 2008 8:02 pm
Contact:

Using Cruncher from a command line

Post by Kier » Wed Jan 30, 2008 8:07 pm

Would it be possible to have Cruncher optimize a model from the command line?

We have an automated process for taking some high poly models to a low poly engine that we would like to use your tool for.

Also, do you guys have any collada plans?

mootools
Site Admin
Posts: 280
Joined: Thu Jul 05, 2007 11:06 am
Contact:

Re: Using Cruncher from a command line

Post by mootools » Fri Feb 22, 2008 5:13 pm

Hello,

No there is no command line available. This could be a good idea as it will let more memory for the optimization.
For the moment, there is a good news.

I am finishing the memory optimization on Polygon Cruncher and the next version will allow to optimize millions of polygons easily.
The next release should be available in a month.

Manuel

Post Reply

Who is online

Users browsing this forum: No registered users and 31 guests