Optimizing a Zspheres mesh in quads?

Exchanges about Polygon Cruncher
Post Reply
curly
Posts: 4
Joined: Sun Dec 06, 2009 6:31 pm
Contact:

Optimizing a Zspheres mesh in quads?

Post by curly » Sun Dec 06, 2009 6:39 pm

Optimizing a Zspheres mesh in quads?

Hi,

Zbrush has very powerful Zspheres to model. Is it possible to optimize an adaptive zspheres mesh into a quad low res model. And in a way that the vertex points are at the spots where the muscles and joints need to flex?

mootools
Site Admin
Posts: 280
Joined: Thu Jul 05, 2007 11:06 am
Contact:

Re: Optimizing a Zspheres mesh in quads?

Post by mootools » Fri Dec 11, 2009 3:16 pm

Hello,

This not possible to perform a quad optimization.
Polygon Cruncher works only with triangle polygon. I hope you will be able to find a workaround to your needs.

Thanks,
Mootools

curly
Posts: 4
Joined: Sun Dec 06, 2009 6:31 pm
Contact:

Re: Optimizing a Zspheres mesh in quads?

Post by curly » Fri Dec 11, 2009 3:56 pm

You can convert triangles in quads. But does polygon cruncher performs well on polygon reduction keeping enough vertices on the joint regions?

mootools
Site Admin
Posts: 280
Joined: Thu Jul 05, 2007 11:06 am
Contact:

Re: Optimizing a Zspheres mesh in quads?

Post by mootools » Mon Jan 11, 2010 12:43 pm

Hello,

I am not sure that trying to rebuild a quad surfaces from an optimization result will give good result.

But may be I don't understand what you are trying to do.
Could you explain what you are calling joint?

Thanks,
Manuel

curly
Posts: 4
Joined: Sun Dec 06, 2009 6:31 pm
Contact:

Re: Optimizing a Zspheres mesh in quads?

Post by curly » Tue Jan 12, 2010 5:11 pm

What I mean is the following. A rigger wants a lot of vector points where he needs them. And tries to avoid vertices on other areas. For instance: Near the elbow you need a lot of vertices to bend the arm. Elsewhere you try to keep the amount of vertices to a minimum. Another example: Near the lips and the eyelids the lips need to flex and the eyes need to close, you need a lot of vertices to perform these animations. Near the knee you need a lot of vertices because it has to bend. etc....

Why quad polygons. In subd modelling the software smooths out quad polygons beter then triangles. (They subdivide better.)

mootools
Site Admin
Posts: 280
Joined: Thu Jul 05, 2007 11:06 am
Contact:

Re: Optimizing a Zspheres mesh in quads?

Post by mootools » Wed Jan 13, 2010 3:17 pm

Thanks for your explanation.
I understand better. May be introducing something like an "optimization gradient" that allows defined where optimization should be the most important, could be interesting.

Another idea for the coming years!
Thanks,
Manuel

curly
Posts: 4
Joined: Sun Dec 06, 2009 6:31 pm
Contact:

Re: Optimizing a Zspheres mesh in quads?

Post by curly » Wed Jan 13, 2010 4:00 pm

In Lightwave they use a Weight Map for that. It would be nice to weight map paint the areas which require a lot of detail direct on the model.

Post Reply

Who is online

Users browsing this forum: No registered users and 32 guests